Ide Kabel Cable Select

Der er så også den 4.

Ide kabel cable select. To do this successfully the jumpers must be configured. One ide ribbon cable can connect a hard drive and a cd drive to the motherboard it can also connect two hard drives to the motherboard. Feb 2009 af rogerrabbit i kategorien hardware pc som de fleste ved sættes ide drev til master slave eller single device master with no slave. Ide ribbon cables have either 40 or 80 wires.

They have 40 pins in total but some have 40 pin 40 conductor ribbon and some have 40 pin 80 conductor ribbon. Cable select only works with the newer 40 pin 80 wire ide cables. Since modern ide controllers simply ground pin 28 at the interface making one of these cables requires no external. Pin 28 on the ide ribbon cable is used for cable select.

This was different from the normal ide cables at the time. There is a connector at each end of the cable and another one about two thirds of the distance from the motherboard connector. With cable select you first needed a special 40 conductor ide cable that would determine master slave connections. Ide cable select sådan virker cable select.

Så er det som navnet siger. Mens det er jumper settings på drevet der bestemmer om det er master eller slave. Cable select jumpering requires a special ide cable with wire. Also the master connector on cs cables was the inside connector not the end connector.

The ide cable is a type of at attachment which has had speeds from 33 66 100 and 133 mb s. When cable select is enabled the drive will configure itself as a master or slave depending on its position in the drive chain. This made for a very confusing switch from everyday master slave configurations. A faster cable can go in a slower hard drive but a slower cable will decrease the speed of a fast hard drive.

The position of the drive on the cable determines if its the master or slave. This cable cannot exceed 18 inches 46 cm in total length 12 inches from first to second connector and 6 inches from second to third to maintain signal integrity. I wouldn t think the jumper would have any effect when its plugged into a ide to sata adapter though. Some info on ide cables.

Drive sees this signal as grounded it s the master but if it floats unconnected it is the slave. Cable select also referred to by the acronym cs is a disk drive jumper setting which automatically sets the priority of a disk drive by its position on its data cable. The difference is just there to improve on i o speeds every second conductor is. All newer ide eide hard drives can be jumpered as cable select cs or csel.